FUTABA 14SG - Page 39

38
<Basic Operation>
11. When a telemetry function is enabled,
the receiving interval (down-link interval) of
sensor data can be changed. If a DL interval
is increased, the response of the sensor data
display becomes slower, but stick response
will improve.
Initial value: 1.0s
Adjustment range: 0.1s~2.0s
* If there are many FASSTest systems turned on around your
receiver, it might not link to your transmitter. In this case,
HYHQLIWKHUHFHLYHUV/(' VWD\VVROLGJUHHQXQIRUWXQDWHO\
the receiver might have established a link to one of other
transmitters. This is very dangerous if you do not notice
this situation. In order to avoid the problem, we strongly
recommend you to doublecheck whether your receiver is
really under control by your transmitter by giving the stick
input and then checking the servo response.
*Do not perform the linking operation when the drive motor
is connected or the engine is running.
* When you use two receivers, please be sure to setup a
"primary" and "secondary" in the "dual" mode.
*A telemetry function cannot be used for the 2nd receiver of
GXDOUHFHLYHUPRGH7KHYROWDJHDQG([WYROWDJHRIDQG
receiver cannot be known with a transmitter.
* You must link one receiver at a time. If both power
supplies to the receivers are switched on simultaneously,
data is received incorrectly by the transmitter.
* If a dual receiver function is used, in order to receive
sensor information correctly by both sets, telemetry data
will be slower compared to a single receiver setup.
* You cannot link three receivers.
/LQNLVUHTXLUHGZKHQDV\VWHPW\SHLVFKDQJHG
/LQNLQJLVUHTXLUHGZKHQHYHUDQHZPRGHOLVPDGH
Warning
After the linking is done, please cycle receiver
power and check that the receiver to be linked
is really under the control of the transmitter.
Do not perform the linking procedure with
motor's main wire connected or with the engine
operating as it may result in serious injury.