FUTABA 14SG - Page 127

126
<Model Menu (Airplane/Glider Functions)>
ƔSRLQWFXUYHVHWWLQJDLUSODQH
>&XUYHUDWHVHWWLQJ@
1. Move the cursor to the curve rate setting
LWHPOHIWVLGH\RXZDQWWRDGMXVWDQGWRXFK
the RTN button to switch to the data input
mode.
 $GMXVWWKHUDWHE\VFUROOLQJWKHWRXFKVHQVRU
 $GMXVWPHQWUDQJHa
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
 7RXFKWKH571EXWWRQWRHQGWKHDGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>0RYLQJFXUYHSRLQW@
1. Move the cursor to the curve point setting
LWHP\RXZDQWWRDGMXVWDQGWRXFKWKH571
button to switch to the data input mode.
 $GMXVWWKHFXUYHSRLQWE\VFUROOLQJWKHWRXFK
sensor.
 $GMXVWPHQWUDQJH8SWRLQIURQWRIWKH
DGMRLQLQJSRLQW
*When the RTN button is touched for one second, the curve
position is reset to the initial value.)
 7RXFKWKH571EXWWRQWRHQGWKHDGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>'HOHWLQJUHWXUQLQJFXUYHSRLQW@
Move the cursor to the curve point setting
LWHP\RXZDQWWRGHOHWHUHWXUQDQGWRXFK
the RTN button for one second.