FUTABA 4pls User Manual

Warning display
The function select switch
screen (P65) can be dis-
played from this screen.
< NO SW >
If function’s ON/OFF
switch is not selected,
<NO SW> is displayed.
82
Function
(Preparation)
- Use the function select switch dial to select the switch. (p.65)
1
(Neutral brake rate)
Select the setting item "NTBRK" by the (JOG) button. Use
the (+) and (-) buttons to set the neutral brake rate.
2
When ending, return to the MENU screen by moving the cur-
sor to the positions other than SW/DIAL and pressing the
(JOG) button
Neutral Brake function adjustment
The ESC neutral brake function and T4PLS neutral brake function can be used simul-
WDQHRXVO\+RZHYHUZKHQVHWWLQJLVGLI¿FXOWWRXQGHUVWDQGZHUHFRPPHQGWKDWRQO\
one neutral brake function be used.
Reference
Throttle Mode "TH MODE"
When the neutral brake function is
"
ON
"
, the neutral brake rate adjustment is auto-
matically assigned to the throttle trim (DT1/2/3/4 or DL1).
Dial / Trim Setting
Throttle side EPA function, or ATL function setting, also affects neutral brake side
operation.
Effect of set value of other functions on neutral brake
Neutral brake "NTBRK"
This is a function select switch dial function. The neutral brake function ON/OFF
switch must be set. (P65)
The neutral brake, which applies the brakes at the neutral position of the throttle trigger,
FDQEHVHW+RZHYHUZKHQXVLQJWKH0&&50&&0&&0&&5RURWK-
HU)XWDED0&0RWRU&RQWUROOHUFRQ¿UPWKDWWKH0&LVLQWKHQHXWUDOSRVLWLRQDQGWKH
set is in the operation mode before setting the neutral brake function switch to ON, the
same as the idle up function (P81). In addition, when the idle up function or throttle off
function (P83) is set, this function has a higher priority than the neutral brake function.
An LED blinks while the neutral brake function is active.
Operation display
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Brake rate (NTBRK)
0 ~ B100
Initial value: 0

FUTABA 4pls Specifications

General

Brand	FUTABA
Model	4pls
Category	Receiver
Language	English