5. Using the System
The previous operations have finished the necessary preparation. Now, the user can run the system and observe
pressure waveforms.
5-1 Selecting Measurement Mode
This software has two measurement modes: monitor mode and maintenance mode.
This section explains the observation of waveforms in monitor mode which is used for normal operation.
* For the observation of waveforms in maintenance mode, refer to Section 7-3-2, “Quick sensor checking”.
(→ Page 37)
Press the “MONITOR MODE” but ton.
The system is waiting for a trigger signal
(measurement start signal) from the molding
machine.
5-2 Selecting Setting Fil e
Press the “SETTINGS” button.
Press the “Open...” button.
* It is located at the lower left of the
setting window.
Select the file and press the “Save” button.
The conditions in the selected settings file are displayed.
The setting file is saved in the amplifier.
* At shipment, the default settings file “Default_Setting.xml” is stored in the amplifier and PC.
* For creating and saving the setting file, refer to Section 4-4, “Setting the Conditions”. (→ Page 23)
To Next Page
Loading...