FUTABA Mold Marshalling System MPS08 - Preface and System Overview; System Introduction and Features; Included Standard Accessories

1
Preface
“Mold Marshalling System” is a system for measuring resin pressure inside injection molds using a strain gage
pressure sensor of Futaba Corporation.
Using the attached measurement software allows you to observe pressure waveforms, store data, and monitor
and set alarms on the personal computer.
Major features are as follows:
 A standard system can measure up to eight channels concurrently.
 Sensitivity of the pressure sensor can be easily performed. (It only needs to input numbers and alphabet.)
 Waveform and historical data of each shot is automatically saved.
 Data is saved in CSV format and can be easily read with commercially available spreadsheet software.
 Six alarm monitoring items can be set for each channel.
 When an alarm occurs, it is possible to output a signal to the robot to sort the defective products.
 Even an amplifier alone enables alarm monitoring. (In this case, data is not saved.)
 The waveforms being measured can be overlaid on the waveforms saved in the past.
Please read this instruction manual carefully and use the product correctly.
If you have any questions, please contact our sales department.
Standard Accessories
 This equipment comes with the following standard accessories.
After unpacking the equipment, make sure that all accessories are included.
- Pressure measurement amplifier “MPS08”: ................................................................................................. 1
- Junction box “UJP04”: .................................................................................. 1 (or 2 if two boxes are ordered)
- Junction cable “WJP0430”: .......................................................................... 1 (or 2 if two cables are ordered)
(One ferrite core for noise suppression comes with one cable.)
- AC adaptor “ES0024010”: ........................................................................................................................... 1
(One ferrite core for noise suppression comes with the adaptor.)
- I/O cable “WCI005”:..................................................................................................................................... 1
- LAN cable “WCL0020”:................................................................................................................................ 1
- Software “PPS series” (CD-ROM, the latest version at the time of shipment): .............................................. 1
- Instruction Manual (This Manual): ................................................................................................................ 1
- Installation Manual: ..................................................................................................................................... 1
- Warranty and Certificate of Registration: ...................................................................................................... 1