Futek IPM650 - Main Display

- 14 -
10 Thomas, Irvine, CA 92618 USA
Tel: (949) 465-0900
Fax: (949) 465-0905
6.3 Main Display
Welcome message will
be displayed at power on
Auto calibration will be applied when device is
turned on. The calibration will minimize any
effects of the temperature drift for either zero
(offset) or span. During the auto calibration process
the key pad is locked out and inaccessible. Brief
information about the active channel will be
displayed when calibration is complete.
Depending on whether TEDS detect is enabled or not (see section 6.8.4), the following Sensor Profile will
be displayed for 10 seconds: TEDS enabled (left), TEDS disabled (right).
CHANNEL 01
SERIAL 1
SENSOR BRIDGE
+2.00000 mV/V
TEMPLATE 33
SERIAL 123456
20.0000 LBS
1.98765 mV/V
AUTO CALIBRATION
IN PROGRESS
PLEASE WAIT 11
....
FUTEK ADVANCED
SENSOR TECH INC.
IPM650-PRO
MADE IN USA