8A089X01 Rev 1
SLIM Installation Manual
3/23/2018 Page 26 of 61
2.5.1.2.4 Mapping The Configuration Table
The bottom of the Map Actions screen shows the Modules configuration table. This is
where the actual configuration between devices is defined. There is one row in the table
for each input. An input can be a button from a radio device or a GPIO input. When the
Module detects the activation of any input it will perform the actions specified (if any) in
the configuration row for that input.
Figure 2-23 Map Actions Table
The Device column indicates the physical device that the input is from. The device label
will match one of the devices shown in the top left input panel diagrams. The device label
is most helpful when two or more devices share similar input names.
Figure 2-24 Device Column
The Input column indicates the name or label of the input. The label will match the ones
shown in the top left input panel diagrams. Together, any row can be exactly identified
and associated with a physical location.
The Description column is a text box allowing a user to type a custom name or meaningful
note to help identify configurations.
The Action column is a drop-down box that defines the general type of output action to
take. Some inputs can be mapped to a siren button, a GPIO output, to toggle PA audio
from the radio, or to a radio control function.
Figure 2-25 Action Column
To Next Page
Loading...
Need help?
General