8A089X01 Rev 1
SLIM Installation Manual
3/23/2018 Page 16 of 61
as one normally would. Then, make sure the Third Party Notification setting is set to “All”.
For example, open the CPS, from the left menu open the Radio Ergonomics Configuration
submenu, select Action Consolidation and for each action which will be used with the
Module set third party notification to “All”.
Radio Ergonomics Configuration > Action Consolidation > Set Third Party Notification
Figure 2-9 Action Consolidation Third Party Notification Setting
If a consolidated action will be set to perform one or more CPS defined actions and also
will be used with the Module then be sure to consider setting a desired Third Party
Notification Error Strategy. If for any reason there were a problem sending an action
notification to the Module, the error strategy setting will determine whether the other
defined actions are carried out or if the consolidated action will exit without completing all
of the other defined actions. If the consolidated action does not contain multiple actions,
and is only being used with the Siren and Light Interface Module, then the Third Party
Notification Error Strategy setting will not matter. For more information on this setting
consult the radio user manual or CPS help guides.
To Next Page
Loading...
Need help?
General