Need help?Do you have a question about the Futurecom Siren & Lights Interface Module and is the answer not in the manual?
General| Brand | Futurecom |
|---|---|
| Model | Siren & Lights Interface Module |
| Category | Control Unit |
| Language | English |
Covers manual revisions, copyrights, disclaimers, and proprietary statements.
Details minimum requirements and technical specifications for the mobile radio.
Explains radio preparation, CPS settings, and disabling Universal Relay Controller.
Outlines requirements for preparing light and siren controllers for integration.
Details connecting the module to a PC via programming cable for configuration.
Explains the general navigation and screens of the configuration utility.
Provides general safety warnings and an overview of the installation process.
Covers mounting procedures, basic installation steps, and critical warnings.
Details general wiring practices and system power connection requirements.
Explains how to connect the module to the radio and light/siren controllers.
Describes the function and connection of the module's GPIO ports.
Specific installation steps for Federal Signal Smart Siren SM and Platinum.
Installation procedures for Whelen CANTROL, CENCOM, and CENCOM Sapphire sirens.
Provides specific instructions for installing the CODE3 Z3 siren.
Recommends practices for ignition sensing, ground wiring, and jump-starting.
Lists replacement parts and device-specific installation references.
To Next Page