Futurecom Siren & Lights Interface Module - Audio Connection

8A089X01 Rev 1
SLIM Installation Manual
3/23/2018 Page 46 of 61
The Siren and Light Interface Module port labeled SIREN-A should never
be used to connect to a Platinum siren or damage to one or both devices
might occur.
4.3.3 Audio Connection
The AUDIO-3 cable provided in interface kit IK-D3 allows the Siren and Light Interface
Module to bring Public Address audio to the siren. Connect the ¼” headphone side of the
AUDIO-3 cable to the Siren and Light Interface Module port labeled PA Connect the RJ11
side of the AUDIO-3 cable to the Smart Controller port labeled MIC located on the rear of
the control head.
The RJ11 end of the AUDIO-3 cable should not be plugged into the
Platinum siren amplifier.