Futurecom Siren & Lights Interface Module - Figure 2-30 Navigation Buttons; Figure 2-31 Programming Utility Connection Status Message; Figure 2-32 Programming Utility Read;Write Status Messages

8A089X01 Rev 1
SLIM Installation Manual
3/23/2018 Page 30 of 61
2.5.1.2.6 Navigation Buttons
The Map Actions screen contains two large buttons: Modify Devices, and Write Module.
The Modify Devices button leaves the Map Actions screen and re-displays the Modify
Devices screen. This allows a user to go back to update their hardware selections. Note
that selecting new hardware may erase existing configurations entries in the Map Actions
table.
The Write Module button sends the active configuration from the utility to the Module.
Figure 2-30 Navigation Buttons
2.5.1.3 Status Line
The bottom line of the programming utility is the status line. It is used to display messages
to the user for key events.
The left side of the status line is used for connection messages. The utility automatically
detects the connection or disconnections of a compatible Module. When a Module is
connected the utility attempts to read and then display the current firmware version.
Example connection messages are shown below:
Figure 2-31 Programming Utility Connection Status Message
The right side of the status line is used for read, write, and programming messages. The
utility will briefly display a confirmation or failure message when a read or write operation
takes place. Example read or write messages are displayed below:
Figure 2-32 Programming Utility Read/Write Status Messages
2.5.1.4 Menu Options
2.5.1.4.1 File Menu
The New menu option allows a user to close or erase any existing configuration settings
and start from a blank configuration.
The Open menu option allows a user to open a configuration file saved on their PC.