All customer supplied wires that connect to the positive terminal of the
battery must be 18AWG or larger, have sufficient insulation, adequately
support the environment of the vehicle, and be fused at the battery. Do
not use circuit breakers with this product.
IMPORTANT!
Wires connecting to the SLIM power harness and GPIO port have the proper terminals
pre-installed. If the customer needs to re-terminate these wires for any reason, the proper
tool must be used to insure proper crimping.
3.4.2 System Power
1. Locate the Power Harness (P/N DDN2348A)
Figure 3-1 Power Connector Position
2. Using appropriately sized wire, extend the RED wire to the Positive (+) battery
terminal. Fuse independently @ 2 Amps.
To Next Page
Loading...