Ganz IP Camera - Audio Configuration

To Next Page

To Previous Page

Audio Configuration

Enable audio

Select the enable check box for the microphone or speaker to be enabled.

Audio Input

Volume: Enter the audio input volume. The available range is from 0 to 225.

Codec: G.711 is supported for the audio codec.

Sampling Frequency: The sampling frequency is selectable between 8kHz and 16kHz.

Audio Output

Volume: Enter the audio output volume. The available range is from 0 to 255.

TCP/IP listen port: Set the port for listening to the audio received from the camera. The default

is 6000 and the range is from 1 to 65535.

Note

After the setting, make sure to click the OK button to save changes.