Ganz IP Camera - TCP Notification

43
5.3.6. TCP Notification
To configure the TCP push for event notification, go to Setup > Event Configuration > TCP Push
Notification.
IP Address, port
Type the configuration of TCP server.
Connect Timeout
TCP push tries to connect to TCP server during the setting time, but if connection is not made
during the setting time, TCP push will stop to try to connect.
Send Timeout
Holding time for data transmission when event occurs.
Alive Type
You can configure the condition of connection and the default value is Timeout.
- Once: Only one connection is made for each event. There is no check that the
connection is succeeded or not.
- Unlimited: The connection continues for data transmission whether event occurs or
not.
- Timeout: After the last data transmission if there is no event for setting time of alive
time the connection will be disconnected.
Alive Time
When alive type is configured as Timeout, the connection will be continued for alive time.