EasyManuals Logo

Gateway MG1 User Manual

Gateway MG1
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
CHAPTER 2: System utilities
42
Setting a Password
To set the Supervisor password:
1 Press or to highlight Set Supervisor Password, then press ENTER. The Set
Supervisor Password box opens.
2 Type a password in the Enter New Password field. The password length cannot
exceed eight alphanumeric characters (A-Z, a-z, 0-9). The password is not case
sensitive.
3 Retype the password in the Confirm New Password field.
Fixed disk boot sector Write protects the boot sector
on the hard drive to protect
against viruses.
Normal or Write Protect
Password on Boot Defines whether a password
is required or not while the
events defined in this group
happened. The sub-options
all require the Supervisor
password for changes and
should be grayed out if the
User password was used to
enter the Setup Utility.
Disabled or Enabled
Caution
When you are prompted to enter a password, you have three tries before the system
halts. Don’t forget your password. If you forget your password, you may have to return your
notebook to your dealer to reset it.
Important
You must set a Supervisor password before you can set a User password.
Caution
Be very careful when typing your password because the characters do not
appear on the screen.
Parameter Description Option

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gateway MG1 and is the answer not in the manual?

Gateway MG1 Specifications

General IconGeneral
BrandGateway
ModelMG1
CategoryLaptop
LanguageEnglish

Related product manuals