GCC Technologies P3-60 - Multiple Copies

Puma III User Manual
Illustrator Plug-In A-4
Multiple Copies
It is suggested to select “Multiple Copies” when you would like to make several copies of one
image on your material to increase cutting accuracy.
Multiple Copies
 No. of X Copies: The numbers of copies on X axis
 No. of Y Copies: The numbers of copies on Y axis
 Range: 1~50. (The more copies you make, the
more time is needed for data transmission.)
 Numbers of X Copies * Numbers of Y Copies =
The total amount of image copies
 Copies with outline：To show outlines of image
graphics
 Margin: Space between marks; must be 0 or ≧ 20,
no negative numbers allowed
The system will create the as shown in the picture below.
X axis
Y axis