GCC Technologies P3-60 - 4.6 Reference Parameter setting for different materials

Puma III User Manual
Operation 4-11
4.6 Reference Parameter setting for different materials
The following reference parameter is used on GCC verified materials shown in the
table.
Material
Wall stickers Magnets Personalized stickers Window decoration
Blade
red green red red
Blade tip length (mm)
0.3 0.8 0.28 0.25
Force (g)
95
580
105
95
Speed (cm/sec)
72
3
72
65
Offset (mm)
0.275
0.5
0.275
0.275
Recommend model
RX, Jaguar, Puma,
EX-P, Bengal, EXII,
AR-24
RX, Jaguar
RX, Jaguar, Puma,
EX-P, Bengal, EXII,
AR-24
RX, Jaguar, Puma,
EX-P, Bengal, EX
II,
AR-24
Material
Vehicle stickers
Reflective film
Cardboard
Blade
red
green
green
Blade tip length (mm)
0.27
0.5
0.3
Force (g)
85 380 165
Speed (cm/sec)
60
3
30
Offset (mm)
0.275
0.5
0.5
Recommend model
RX, Jaguar, Puma,
EX-P, Bengal, EXII,
AR-24
RX, Jaguar, Puma,
EX-P, Bengal
RX, Jaguar, Puma,
EX-P, Bengal, EXII, AR-24
Material
Window tint Protective tint Rhinestone
Blade
red green green
Blade tip length (mm)
0.09 0.3 0.8
Force (g)
70
320
190
Speed (cm/sec)
72
3
15
Offset (mm)
0.275
0.5
0.5
Recommend model
RX, Jaguar, Puma,
EX-P, Bengal, EXII,
AR-24
RX, Jaguar, Puma,
EX-P, Bengal
RX, Jaguar, Puma