Puma III User Manual
Installation 2-1
Chapter 2 Installation
2.1 Precaution
Notice 1
Carefully handle the cutter to prevent any injuries.
Make sure the power switch is off before installing the cutting plotter.
Notice 2 A proper place for installation the cutting plotter
Please select a proper location that meets the following conditions.
The machine can be approached easily from any direction.
Keep at least 60 cm space in front and behind the machine.
Make sure the cutter is placed on a flat, level and sturdy surface
The operation temperature should be between 15 and 30
(60-86
o
F) in the
workshop.
Keep the relative humidity between 25% and 75% in the workshop.
Protecting the machine from dust and air current.
Preventing the machine from direct sunlight.
Notice 3 Connecting the Power Supply
Check the plug of the power cord to see if it matches the wall outlet. If not, please
contact your dealer.
Insert the plug (male) into a grounded power outlet.
Insert the other end (female) of power cord into the AC connector of cutting
plotter.
To Next Page
Loading...
