Puma III User Manual
GreatCut Plug-In A-5
Step 5 Complete the Number in X/Y (the number of copies desired on the X/Y axis) and
Distance in X/Y (distance between each copy) settings then click OK.
Note: The spacing of vertical & horizontal (Offset X & Y) should be ≥ 20mm or = 0mm; users are
advised to set the Distance in X/Y as 0 mm to remove the space between each copy to
avoid the waste of materials.
Step 6 The system will create several copies of the object with registration marks as shown in
the picture below.
Follow the same steps in the Output section to output your image to GCC Cutting Plotter.
To Next Page
Loading...
