GCC Technologies P3-60 - Page 5

Puma III User Manual
Contents
4.6 Reference Parameter setting for different materials
4-11
5. Automatic-Aligning System
5.1 Introduction
5-1
5.2 AAS Contour Cutting System
5-2
5.2.1 Notice for Registration Marks
5-2
5.2.2 AAS II on Puma III
5-3
5.3 Printer Test
5-4
5.4 Registration Mark Offset Range
5.5 Contour Cutting
5-6
5-6
5.6 Tips for AAS
5-8
6. Basic Maintenance
6.1 Cleaning the cutting Plotter
6-1
6.2 Cleaning the Grid Drum
6-2
6.3 Cleaning the Pinch Rollers
6-2
7. Trouble Shooting
7.1 Non-Operational Problems
7-1
7.2 Operational Problems
7-2
7.3 Communication Problems
7-3
7.4 Software Problems
7-4
7.5 Cutting Quality Problems
7-5
Appendix
A-1
Specifications of Puma III
A-1
A-2
Blade Specification
A-2
A-3
CorelDRAW Plug-In Instruction
A-3
A-4
Illustrator Plug-In Instruction
A-4
A-5
GreatCut Plug-In Instruction
A-5
A-6
SignPal 12 Instruction
A-6
A-7
Sure Cuts A Lot
A-7