GE AF-650 GP - Page 199

No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter
Reference
1 10 Volts low X
2 Live zero error (X) (X) par. AN-01 Live Zero Time-
out Function
3 No motor (X) par. H-80 Function at Stop
4 Mains phase loss (X) (X) (X) par. SP-12 Function at Line
Imbalance
5 DC link voltage high X
6 DC link voltage low X
7 DC over-voltage X X
8 DC under voltage X X
9 Inverter overloaded X X
10 Motor Electronic OL over temperature (X) (X) par. F-10 Electronic Over-
load
11 Motor thermistor over temperature (X) (X) par. F-10 Electronic Over-
load
12 Torque limit X X
13 Over Current X X X
14 Earth Fault X X X
15 Hardware mismatch X X
16 Short Circuit X X
17 Control word time-out (X) (X) par. O-04 Control Word
Timeout Function
22 Hoist Mech. Brake
23 Internal Fan Fault X
24 External Fan Fault X par. SP-53 Fan Monitor
25 Brake resistor short-circuited X
26 Brake resistor power limit (X) (X) par. B-13 Braking Thermal
Overload
27 Brake chopper short-circuited X X
28 Brake check (X) (X) par. B-15 Brake Check
29 Heatsink temp X X X
30 Motor phase U missing (X) (X) (X) par. H-78 Missing Motor
Phase Function
31 Motor phase V missing (X) (X) (X) par. H-78 Missing Motor
Phase Function
32 Motor phase W missing (X) (X) (X) par. H-78 Missing Motor
Phase Function
33 Inrush Fault X X
34 Network communication fault X X
36 Mains failure X X
38 Internal Fault X X
39 Heatsink sensor X X
40 Overload of Digital Output Terminal 27 (X) par. E-00 Digital I/O Mode,
par. E-51 Terminal 27 Mode
41 Overload of Digital Output Terminal 29 (X) par. E-00 Digital I/O Mode,
par. E-52 Terminal 29 Mode
42 Overload of Digital Output On X30/6 (OPCGPIO) (X) par. E-56 Term X30/6 Digi
Out (OPCGPIO)
42 Overload of Digital Output On X30/7 (OPCGPIO) (X) par. E-57 Term X30/7 Digi
Out (OPCGPIO)
46 Pwr. card supply X X
47 24 V supply low X X X
48 1.8 V supply low X X
49 Speed limit X
50 Auto Tune calibration failed X
51 Auto Tune check U
nom
and I
nom
X
52 Auto Tune low I
nom
X
53 Auto Tune motor too big X
Table 5.1: Alarm/Warning code list
AF-650 GP Programming Guide
198
5