GE D400 - Cleaning and handling Lithium batteries; Dual ethernet upgrade kit with card 580-2717

102 GENERAL D400 SUBSTATION GATEWAY USER’S MANUAL
DUAL ETHERNET UPGRADE KIT WITH CARD 580-2717 CHAPTER 8: SERVICING THE D400
Cleaning and handling Lithium batteries
• Wear gloves or finger caps when handling batteries to keep them clean.
• Use non-conductive cleaning solution to prevent deterioration of battery performance
• Dry batteries at a temperature below 85 °C to prevent seal deterioration that may, in
turn, result in leakage
Recycling of batteries
The D400 Lithium battery is recyclable and does not contain mercury, cadmium, or lead in
levels above those regulated by the European Union. Recycle the battery according to local
waste management regulations.
In accordance with European Directive 2006/66/EC, batteries are marked
with the crossed out wheeled bin, which indicates that they cannot be
disposed of as unsorted municipal waste in the European Union. Users of
batteries must use the collection points available to customers for the
return, recycling, and treatment of batteries. Customer participation is
important to minimize the negative effects of batteries to the environment and sustain
available natural resources. For more information see www.weeerohsinfo.com.
Battery life
If the battery is disconnected, or if the D400 is never powered down, the life of the battery
should exceed five years. The life of the battery will be severely shortened if the battery is
left connected while the D400 is powered down for extended periods or stored.
For long-term storage:
• Remove the battery
• Keep the equipment at temperatures and humidity below normal
• Avoid shorting or loading while stored
Dual ethernet upgrade kit with card 580-2717
The D400 Dual Ethernet Upgrade Kit allows you to upgrade your existing D400 device to
support dual Ethernet network connections. This upgrade kit contains the following
components:
• PC/104-Plus 10/100BaseT Ethernet Module card (GE part number 580-2717)
• Ethernet card to main board cable assembly (GE part number 975-0122)
• Phillips screws (4 pieces)
• Hexagonal standoffs (4 pieces)
• Hexagonal nuts (4 pieces)
Valid combinations
This upgrade can be performed using the following components:
D400 Main Board Ethernet Module Card Network Cards
GE part no. 520-0204 [650 MHz]
GE part no. 520-0205LF [1.0 GHz]
GE part no. 580-2717
Compatible with all released
versions of D400 firmware
GE part no. 520-0218LF [NET1 slot]
GE part no. 520-0213LF [NET2 slot]
GE part no. 520-0214LF [NET2 slot]
GE part no. 520-0215LF [NET2 slot]