GE D400 User Manual

CHAPTER 1: BEFORE YOU START ORDERING GUIDE
D400 SUBSTATION GATEWAY USER’S MANUAL GENERAL 19
– Altera Quartus programmer
– D400 upgrade manager utility
– D400 FPGA firmware
• USB Blaster cable
When ordering upgrade kits with the Dual Ethernet controller, ensure that the existing
D400 unit to be upgraded is equipped with the second network card option.
Product identification number
The D400 comes with an ID number that identifies the supplied options and hardware
configuration of the unit. This ID number is composed of
* followed by 6 alphanumeric
characters. The ID number is listed on a label located next to Slot 1 on the rear panel of the
D400.
Figure 2: D400 identification number
Location of ID number label

GE D400 Specifications

General

Brand	GE
Model	D400
Category	Gateway
Language	English