GE D400 User Manual

CHAPTER 6: SETTING UP THE D400 SETTING UP THE NETWORK INTERFACE
D400 SUBSTATION GATEWAY USER’S MANUAL GENERAL 85
Setting up the network interface
To set up the D400’s network interface, you will need the following information:
• D400’s assigned IP address
• Subnet Mask
• Gateway address (if applicable)
This set up must be done the first time from the D400’s front serial communications port.
To configure the
network interface
1. Connect to the front maintenance port. See “Connecting to the D400 for the first time”
on page 83.
2. At the D400#>> prompt, type d400cfg and press Enter.
Result: The D400 Configuration Utility menu appears.

GE D400 Specifications

General

Brand	GE
Model	D400
Category	Gateway
Language	English