104 GENERAL D400 SUBSTATION GATEWAY USER’S MANUAL
DUAL ETHERNET UPGRADE KIT WITH CARD 580-2717 CHAPTER 8: SERVICING THE D400
5. Ensure that rotary switch U11 on the Ethernet Module card is set to position 2.
Figure 56: Dual Ethernet upgrade kit - rotary switch position
6. Attach the Ethernet Module card to the expansion slot and secure using the four
provided Philips screws.
Figure 57: Dual Ethernet upgrade kit with card 580-2717 - attach Ethernet module card
7. Replace the D400 main module.
8. Power up the D400 and configure the network connections as required using d400cfg.
Refer to the D400 Configuration Utility section in the D400 Substation Gateway
Software User’s Manual for more information.
Switch must be set
To Next Page
Loading...
