EasyManua.ls Logo

GE D400 - Environmental standards

GE D400
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
APPENDIX A: STANDARDS & PROTECTION COMPLIANCE STANDARDS
D400 SUBSTATION GATEWAY USER’S MANUAL GENERAL 113
Table 28: Environmental standards
Table 29: Communication standards
1
To comply, the D400 Substation Gateway BIOS Spread Spectrum clock setting must be
set to “disable”. This is the factory default.
2
To comply, the D400 Substation Gateway BIOS DRAM clock setting must be set to “HCLK-
33M”. This is the factory default.
Standard Name Description Test Specification
IEC 60068-2-1 Cold 2 hours non powered, soak at
40 °C, then warm to 20 °C and
leave powered for 16 hours
IEC 60068-2-2
2
Dry Heat 16 hours powered at +70 °C
IEC 60068-2-6
IEC 60255-21-1
Vibration (sinusoidal) A logarithmic sweep from 10 Hz
to 150 Hz to 10 Hz at 1 oct/min
for 1 sweep cycle in the 3
orthogonal axes.
Acceleration level 1 g
IEC 60068-2-27 Shock - Operating Response Test
Shock - Non-Operating Withstand Test
Pulse shape: Half sine Pulse
duration: 11 mS
- Operating Response Test:
Acceleration level: 5 g's
- Non-Operating Withstand
Test: Acceleration level: 15 g's
3 pulses per polarity per axis for
a total of 18 pulses
IEC 60068-2-29 Bump – Non operating test Pulse shape: Half sine Pulse
duration: 11 mS Acceleration
level: 10 g's
1000 pulses per polarity per axis
for a total of 6000 pulses
IEC 60068-2-30 Damp heat, cyclic (12 h + 12 h cycle)
IEC 60068-2-31 Drop and topple Dropping on each face Dropping
on each corner Toppling (or
pushover)
For a total of 12 drops
IEC 60068-2-78 Humidity Testing 96 hours steady state humidity
at 40 °C & 93% RH
IEC 60255-21-2 Shock and bump tests
IEEE 1613, Section
4.1.1
Power Supply Temperature Testing
Operational
Temperature range:
20 °C to +70 °C
IEEE 1613, Section
4.1.1
Power Supply Temperature Testing Non-
operational
Temperature range:
40 °C to +85 °C
Standard Name Description Test Specification
IEEE 802.3 CSMA/CD Access Method (and physical
layer specifications)
IEC 61850-3 Communication networks and systems in
substation – General requirements
IEEE 802.3 CSMA/CD Access Method (and physical
layer specifications)

Table of Contents

Other manuals for GE D400

Related product manuals