Monitoring ECG
2000966-386D Dashâ„¢ 3000/4000/5000 8-13
îš„ Arrhythmia alarm levels
îš„ HR, PVC and ST parameter alarm levels
îš„ ECG SIZE
îš„ DETECT PACE
îš„ ARRHYTHMIA
îš„ ST ANALYSIS
îš„ LEAD ANALYSIS
îš„ HR HIGH LIMIT and HR LOW LIMIT
îš„ PVC LIMIT and PVC state
To select the source of ECG settings, follow this procedure.
1. Select MORE MENUS > MONITOR SETUP > MONITOR DEFAULTS >
SETUP DEFAULT DISPLAY.
2. Locate and select COMBO DEFAULT SOURCE.
3. Select one of the following:
 TELE DEFINED — Use the telemetry ECG settings. This is the factory
default.
 USER DEFINED — Use the monitor’s ECG settings if telemetry is NOT
admitted. Use the telemetry ECG settings if telemetry IS admitted.
ECG Setting Source When Entering COMBO Mode
The following tables indicate the source (monitor or telemetry) of ECG settings when
entering COMBO mode.
Notice that selecting Tele Defined means the ECG setting source is always telemetry
when entering COMBO mode, while the ECG setting source for User Defined
depends on whether the patient is admitted to the monitor or telemetry when entering
COMBO mode.
Tele Defined
Monitor Telemetry Entering COMBO Mode ECG Setting Source
Not admitted Not admitted >
Telem etryAdmitted Not admitted >
Not admitted Admitted >
User Defined
Monitor Telemetry Entering COMBO Mode ECG Setting Source
Not admitted Not admitted >
Monitor
Admitted Not admitted >
Not admitted Admitted > Telemetry
To Next Page
Loading...
Need help?
General
