2-8 Dash™ 3000/4000/5000 2000966-386D
Equipment Overview
Green — The battery is fully charged.
No light — The battery is not installed, not charging or “asleep”. Or the monitor
is using this battery for power.
Battery Status
Indicates the power status of the internal batteries. One inside each battery door.
Green — The monitor is using this battery for power.
No light — The monitor is not using this battery for power.
Optional Components
TRAM-RAC 2A Module Housing
The TRAM-RAC 2A module housing supports one single-parameter module. It has
an optional internal power supply that runs the module housing and supports the
needed voltages.
Single-Parameter Modules
Use the following single-parameter modules in the TRAM-RAC 2A module housing
to acquire the patient’s physiological data and view it on the monitor.
SAM Module
The Smart Anesthesia Multi-gas (SAM) module is an infrared based, multi-gas
analyzer module that measures inspired and expired values for patient gases and
calculates respiratory rate. For more information, refer to Chapter 16.
Solar ICG Module
The Solar ICG (impedance cardiography) module uses thoracic bioimpedance
technology (TEB) to provide non-invasive, continuous hemodynamic data. For more
information, refer to Chapter 17.
Nellcor
®
395 Pulse Oximeter
The Nellcor 395 pulse oximeter is an external pulse oximeter that sends SpO
2
parameter data, including saturation and rate, to the monitor for review and print. You
can connect this device to the monitor, the docking station or both. For more
information, refer to Nellcor 395 Pulse Oximeter on page 11-11.
Unity Network
The Unity Network is a purchased software option that must be enabled in order use a
central station, remote display, wireless LAN system or any other networked device.
To Next Page
Loading...
Need help?
General
