GE Multilin 850 User Manual

4–12 850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
DEVICE CHAPTER 4: SETPOINTS
DST START HOUR
Range: 0 to 23
Default: 2
DST END MONTH
Range: January to December (all months)
Default: Not Set
DST END WEEK
Range: 1st, 2nd, 3rd, 4th, Last
Default: Not Set
DST END DAY
Range: SUN to SAT (all days of the week)
Default: Not Set
DST END HOUR
Range: 0 to 23
Default: 2
IRIG-B
IRIG-B is available in the basic offering of the product. A failure on IRIG-B triggers an event
and a target message.
FAST PATH:
Note that IRIG-B is auto detect. The signal type is detected in hardware, so there are no
configurable options.
SNTP Protocol Path: Setpoints > Device > Real Time Clock > SNTP
SNTP FUNCTION
Range: Disabled, Enabled
Default: Disabled
SNTP SERVER IP ADDRESS
Range: Standard IP Address Format
Default: 0.0.0.0
SNTP UDP PORT NUMBER
Range: 0 to 65535 in steps of 1
Default: 123
SNTP SERVER 2 IP ADDRESS
Range: Standard IP Address Format
Default: 0.0.0.0
SNTP 2 UDP PORT NUMBER
Range: 0 to 65535 in steps of 1
Default: 123
FAST PATH:
The SNTP and PTP settings take effect after rebooting the relay.

GE Multilin 850 Specifications

General

Brand	GE
Model	Multilin 850
Category	Protection Device
Language	English