GE Multilin 850

4–62 850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
DEVICE CHAPTER 4: SETPOINTS
LINE 1 TEXT
Range: 2 lines of alphanumeric characters
Default: [blank]
This setting specifies the text that is displayed on Line 1 of the button when in the
normal view.
LINE 2 TEXT
Range: 2 lines of alphanumeric characters
Default: [blank]
This setting specifies the text that is displayed on Line 2 of the button when in the
normal view.
LINE 1 SHORT TEXT
Range: 2 lines of alphanumeric characters
Default: [blank]
This setting specifies the text that is displayed on Line 1 of the button when in the
summary view. This is also the text that appears on the tabs when operating the
pushbuttons from the Single Line Diagram view.
LINE 2 SHORT TEXT
Range: 2 lines of alphanumeric characters
Default: [blank]
This setting specifies the text that is displayed on Line 2 of the button when in the
summary view.
BUTTON COLOR
Range: Black, Red, Yellow, Blue, Green, Teal, Purple, White
Default: Black
This setting specifies the background color of the Tab Pushbutton. If the button is
disabled, the button color by default is shown as grey.
TEXT COLOR
Range: Black, Red, Yellow, Blue, Green, Teal, Purple, White
Default: White
This setting specifies the text color of the Tab Pushbutton.
INDICATOR COLOR
Range: Black, Red, Yellow, Blue, Green, Teal, Purple, White
Default: Yellow
This setting specifies the color of the “LED” indicator for the Tab Pushbutton.
INDICATOR TRIGGER
Range: TAB PB 1 ON, Any FlexLogic operand
Default: TAB PB 1 ON
This setting assigns a FlexLogic operand to trigger the Indicator to change color from
the default color (white) to the selected color.
HOLD PRESSED
Range: 0.1 to 10.0 s in steps of 0.1 s
Default: 0.1 s
This setting specifies the time required for a pushbutton to be pressed before it is
deemed active.
The timer is Reset upon release of the pushbutton. Note that any pushbutton operation
will require the pushbutton to be pressed a minimum of 100ms.