GE Multilink ML3000 User Manual

CHAPTER 1: INTRODUCTION INTRODUCTION
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 1–29
 Save this file on FTP or TFTP. Ensure the FTP or TFTP path is
configured. If using FTP, record the FTP login name and password.
 Select the switch to upgrade. Ensure you have system administration
privileges available on the switch.
 Open a EnerVista Secure Web Management software session with
the switch by typing in the following URL:
https://<IP address of the switch>
If using FTP, save the configuration before proceeding. GE Multilin recommends a two-step
update: first save the configuration to the ftp server, then load the new image and restart
the switch (refer to Saving Configuration on page 5–20 for details on saving the
configuration).
 Load the new firmware as shown below.
As the file is being loaded, the firmware will display the transfer in progress window.
 Reboot the switch when the transfer is complete.
After reboot, the firmware is ready for use.
 If using TFTP, save the configuration before proceeding.
GE Multilin recommends a two-step update:

GE Multilink ML3000 Specifications

General

Brand	GE
Model	Multilink ML3000
Category	Network Router
Language	English