GE Multilink ML3000 User Manual

1–30 MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
INTRODUCTION CHAPTER 1: INTRODUCTION
• first save the configuration to the TFTP server,
• then load the new image and restart the switch (refer to Saving
Configuration on page 5–20 for details on saving the
configuration).
 Load the new firmware as shown below.
As the file is being loaded, the firmware will display the transfer in progress window.
 Reboot the switch when the transfer is complete.
After reboot, the firmware is ready for use.

GE Multilink ML3000 Specifications

General

Brand	GE
Model	Multilink ML3000
Category	Network Router
Language	English