GE Optica - Page 84

Programming the 4x40 Optica 5-3
January 2006
Programming Technique
(cont.)
A typical programming screen (for setting the Analog Outputs) is
shown in Figure 5-2 below.
Figure 5-2: Typical Analog Outputs Programming Screen
An example of programming the Serial Baud Rate is shown in below.
Press the DOWN and RIGHT (>>>>) softkeys as shown to select the
parameter to be programmed, choose the value using the UP and
DOWN softkeys, and press ENTER.
Figure 5-3: Programming the 4x40 Optica
>> Temperature
Output A Parameter
Analog Outputs UP
<<<<
DOWN
and/or return to previous position.
Press "left" softkey (<<<<) to cancel
Down
Serial Output
Up
Units
Parity
DOWN
UP
DOWN
Baud
UP
Analog Outputs
Down
Parameters
Communication
Down
Up
Up
>>>>
Serial Mode
DOWN UP
ENTER
DOWN
300
UP
1200
DOWN
DOWN
>>>>
600
UP
UP
set
Baud rate