GE PACE Series User Manual

viii K0472 Revision A
Code Definitions
The following codes are used in this manual.
ABOR Abort LIM Limit
ADDR Address LLO Local lock out
AVER Average LOG Logical
ALT Altitude LPAS Low pass (filter)
AMPL Amplitude MAV Message available in output queue
ATOD Analog to Digital MEAS Measure
BAR Barometer MSS Summary bit after SRQ
BRID Bridge NEGC Negative Calibration
CAL Calibration OFFS Offset
CAT Catalogue OPC Operational condition
CDIS Cdisable (calibration disable) OPER Operation
CEN Cenable (calibration enable) OPT Option
CLS Clear OSB Summary bit from standard operations status register
COMM Communicate OVER Overshoot
COMP Compensate OUTP Output
COND Condition PAR Parity
CONF Configuration PASS Password
CONT Controller PERC Percent
CONV Convert POIN Points
CORR Correction PRES Preset
COUN Count PRES Pressure
DEF Define QUE Queue
DIAG Diagnostic QUES Questionable
DIOD Diode RANG Range
DISP Display REF Reference
EAV Error in error queue RES Resolution
EFF Effort RES RESet
ENAB Enable SAMP Sample
EOI End of input SENS Sense
ERR Error SEPT Set-point
ESB Summary bit from standard event SER Serial
ESE Event status enable SOUR Source
ESR Event status register SPE Speed
EVEN Event SRE Service request enable
FILT Filter SRQ Service request
FREQ Frequency STAR Start
FULL Fullscale STB Status register query
GTL Go to local STAT State
HEAD Head SYST System
IDN Identification TIM Time to set-point
IMM Immediate UNIT Unit of pressure
INL In limit VAL Value
INP Input VALV Valve
INST Instrument VERS Version
ISOL Isolation VOL Volume
LEV Level

GE PACE Series Specifications

General

Brand	GE
Model	PACE Series
Category	Test Equipment
Language	English