GE PACE Series

PACE Series SCPI Manual
K0472 Revision A 4-3
CALibration
The CALibration subsystem enables the calibration of the transducers and the rate control
system, refer to the user manual for further details.
:CAL:PRES:POIN
Applicability: PACE1000, PACE5000, PACE6000
Command Syntax
n/a
Parameter:
Short form:
Function:
Defaults:
Query Syntax
:CALibration[x]:[PRESsure]:POINts?
where: x (module) = 1 or 2 (default - 1).
Short form: CAL:POIN?
Function: Gets the number of calibration points
Response: 3
Description
Valid only when calibration is enabled, this queries the number of calibration points.
Example
Tx> :CALibration2:PRESsure:POINts?
Rx> :CAL2:PRES:POIN 3