PACE Series SCPI Manual
K0472 Revision A 4-93
:SOUR:PRES:SLEW
Applicability: PACE5000, PACE6000
Command Syntax
:SOURCE[x][:PRESsure]:SLEW <number>
where x = 1 or 2 is the module number
(default - 1)
Parameter: <decimal> rate in pressure units/second or enumerated string maximum
or minimum rate.
Short form: SOUR:SLEW <number> or maximum or minimum rate
Function: Selects the pressure rate used when value rate is selected.
Default: 100
Query Syntax
:SOURCE[x][:PRESsure]:SLEW?
where x = 1 or 2 is the module number
(default - 1)
Short form: :SOUR:SLEW?
Function: Query rate value
Response: Decimal number representing rate value in selected units/second.
Description
When the controller rate is selected as value, this command is used to set the controllers
rate in selected units/second.
Example
TX> :SOUR:PRES:SLEW?
RX> :SOUR:PRES:SLEW 2.0000000
Change current unit of mbar to bar and query again:
TX> :SOUR:PRES:SLEW?
RX> :SOUR:PRES:SLEW 0.0020000
To set slew rate to other values, such as:
TX> :SOUR:PRES:SLEW 4
TX> :SOUR:PRES:SLEW?
RX> :SOUR:PRES:SLEW 4.0000000
TX> :SOUR:PRES:SLEW max
TX> :SOUR:PRES:SLEW?
RX> :SOUR:PRES:SLEW 99999999.0000000
TX> :SOUR:PRES:SLEW min
TX> :SOUR:PRES:SLEW?
RX> :SOUR:PRES:SLEW 0.0
To Next Page
Loading...
Need help?
General
