4 Command and Query Summary
K0472 Revision A 4-10
:CAL:PRES:ZERO:TIME:STAT
Applicability: PACE5000, PACE6000
Command Syntax
:CALibration[x]:[PRESsure]:ZERO:TIME:STATe
where: x (module) = 1 or 2 (default - 1)
Parameter: <<boolean>>
Short form: :CAL:ZERO:TIME:STAT1
Function: Sets timed zero on/off.
Default: 0
0 - sets timed zero to OFF
1 - sets timed zero to ON
Query Syntax
:CALibration[x]:[PRESsure]:ZERO:TIME:STATe?
where: x (module) = 1 or 2 (default - 1)
Short form: :CAL:ZERO:TIME:STAT?
Function: Queries the status of the timed zero ON or OFF.
Response:
:CAL:ZERO:TIME:STAT 1
or
:CAL:ZERO:TIME:STAT 0
Description
This command sets the time period for zero on or off. This query gets the status of the timed
zero (on or off).
To Next Page
Loading...
Need help?
General
