Chapter 3
Using staff consoles and annunciators
Telligence Patient-Staff Communication System Operation Manual 23
Displaying the screen you need
To change the screen displayed on the staff console or annunciator,
touch the corresponding screen selection tab. Screen selection tabs
are continuously displayed at the bottom of each screen.
Figure 11: Screen selection tabs
The following table shows which tab to select in order to display the
screen you need.
Table 4: Screen selection tabs corresponding to specific tabs
To perform this task Select this tab
Adjust alert tone volume Audio tab
Adjust the call volume Audio tab
Answer a call Calls tab
Answer a reminder Reminders tab
Clean the touch screen Admin tab
Clear a reminder (normal priority) Reminder tab
Configure call priorities for a room or
bed
Room list tab
Hang up or cancel a call Audio tab
Place a call Room List tab
Recalibrate the touch screen Admin tab
Set a reminder Audio tab
Turn off alert tones Call tab, Reminders tab, Room List
tab
Upgrade a call to a higher priority Audio tab
To Next Page
Loading...
