Chapter 3
Using staff consoles and annunciators
Telligence Patient-Staff Communication System Operation Manual 45
Resolving staff console and annunciator problems
Resolutions to some problems that may occur at staff consoles or
annunciators are provided here.
Errors at staff consoles and annunciators
If a staff console or an annunciator experiences an error, an alert
will be signaled by messages appearing at other staff consoles or
annunciators, and/or by the flashing and toning of the dome light
supervising the staff console or annunciator.
A four-section HC-CL4-SUPV supervisory dome light fast flashes
white in all four of its light sections, and sounds tones at the rate it is
flashing, to signal loss of power and data to the supervised staff
console or annunciator. When the status of a supervised device
becomes normal, all four dome light sections extinguish and dome
light tones cease.
To resolve a staff console or annunciator error:
1. Disconnect power to the staff console or annunciator, then plug
it in again.
If removing power from, followed by restoring power to, the staff
console or annunciator does not resolve the problem, contact the
GE Security Technical Services Department at 1-800-385-2639
during normal business hours.
To Next Page
Loading...
