Chapter 4
Patient stations
58 Telligence Patient-Staff Communication System Operation Manual
Note: When multiple
calls are placed, the
system always
responds to the highest
priority call. These
sections describe the
system response when
no other call is active.
Using patient stations
You can use the Telligence patient station itself to directly place
nurse calls. Patients use controls on smart pillow speakers, call
cords, or bed side-rails that are connected to the patient station to
place nurse calls. This section covers staff use of the Telligence
patient station, and summarizes how patients place nurse calls. For
more discussion about patient nurse call placement, see later
sections in this chapter.
• Placing a call from the patient station
• Nurse calls of a variety of priorities can be made from the
Telligence patient station.
The following section describes how the system responds when a
call is placed by pushing a call station command button.
Code blue call
• Code lights on the patient station and on any linked stations
• Call status lights on single and dual patient stations
• Call assurance feedback tone at the patient station
• All light sections of associated corridor and zone lights fast flash
blue.
• Associated zone lights emit a fast, repeating buzz.
• Code blue tones sound at staff consoles, annunciators, and duty
stations where the staff follow function is active.
• The call appears on the Call screen on staff consoles and
annunciators.
Staff emergency call
• Emerg lights on the patient station and on any linked stations
• Call status lights on single and dual patient stations
• Call assurance feedback tone at the patient station
• Top light sections of associated corridor and zone lights fast
flash red.
• Associated zone lights emit a fast, repeating buzz.
• Staff emergency tones sound at staff consoles and
annunciators, and at stations where the staff follow function is
active.
• The call appears on the Call screen on staff consoles and
annunciators.
To Next Page
Loading...
