GE Ultrasonic USM Go - 3.1.1 b Adjusting the Gate Width; 3.8.1 Recording the DAC Curve

Chapter 3. Making Measurements
66 USM Go Operator’s Manual
3.1.1b Adjusting the Gate Width (GATE A WIDTH or GATE B-GATE WIDTH)
1. In the ACQUIRE menu, activate the GATE A or GATE B submenu using the joystick ( ).
2. Use the joystick ( ) to select the GATE A WIDTH (or GATE B WIDTH) function.
3. To change the gate width, either move the joystick ( ) or press the function toggle.
Note: This function has both coarse and fine adjustment modes. Coarse adjustments are made with the function toggle, while fine
adjustments are made with the joystick.
4. After completing your selection, move the joystick up or down ( ) to navigate away from this function.