Stop
Back
7
8
9
456
1
2
3
Confirm
16
4.
process of automatic leveling of the printer, otherwise leveling may
fail.
5. During the leveling process, if the test fails at a certain point, the
printer will repeat the test for several times. Please wait patiently. If
the test succeeds, the next test will be carried out. If it fails, the
printer will remind“Probing Failed”. At this point, please check
whether the hot end is loose, whether the 3D printer is placed
horizontally, whether the environment is vibrated, etc., and then
select "Reset" to restart the system and try leveling again.
1. Please check whether the connection between the main board and
the hot end is normal or broken.
2. Remove the hot end cover and check whether the internal wiring is
loose or broken.
3.
and level it again.
4. Sensor damage, please contact after-sales personnel to solve;
5. The nozzle heating is abnormal, please check whether the nozzle
connection line is normal.
6. After leveling is completed, you can start using the printer.
Abnormal Failure of auto-level elimination:
1.
2. After entering the "Manual Leveling" interface, the hot end will auto
home. When the auto-homing is completed, the screen will prompt
9.2 Manual Level.
Reset
To Next Page
Loading...
Need help?
General
