32 50950260/AP1216
Never push the left pedal into the float position
with the attachment loaded or raised, because
this will cause the lift arm to lower rapidly.
Auxiliary Hydraulic Controls
Auxiliary hydraulics are used with attach-
ments that have a mechanism requiring
hydraulic power.
Important: Always be sure the auxiliary
hydraulic control is in neutral before
starting the loader or removing the auxil-
iary hydraulic couplers.
Note: When ignition power is interrupted,
auxiliary hydraulic function is reset to
OFF.
Couplers are located on the left lift arm.
“A” port is pressure, “B” port is return
when the auxiliary control is in the detent position (refer to page 45).
T-Bar Controlled Loaders
A foot pedal is used to control the direc-
tion of oil flow.
Hand/Foot Controlled Loaders
The right handle controls the direction of
oil flow. A locking pin locks it in the up
position for continuous operation.
Figure 12 Auxiliary Couplers
A
B
Figure 13 T-Bar Auxiliary
Control
Figure 14 Hand/Foot
Auxiliary Control
To Next Page
Loading...