52 50950260/AP1216
Lifting the Loader
The loader can be lifted using a single-point or four-point lift kit, which is avail-
able from your Gehl dealer.
• Before lifting, check the lift kit for proper installation.
• Never allow riders in the operator’s compartment while the loader is lifted.
• Keep everyone a safe distance away from the loader while it is lifted.
• Loader may only be lifted with an empty bucket or empty pallet forks, or with no
attachment. Never lift the loader with attachments other than those stated.
Lift equipment used and its installation is the responsibility of the party con-
ducting the lift. All rigging MUST comply with applicable regulations and
guidelines.
1. Using suitable lift equipment, hook into the lift eyes. Adjust the length of the
slings or chains to lift the loader level.
Important: As needed, use a spreader bar to prevent the slings or chains from
rubbing the sides of the ROPS/FOPS. (Four-point lift only)
Note: The loader may be slightly off level (10 degrees max.) when lifted.
2. Center the hoist over the ROPS/FOPS. To prevent shock loading of the equip-
ment and excessive swinging, slowly lift the loader off the ground. Perform
all movements slowly and gradually. As needed, use a tag line to help posi-
tion the loader and keep it from swinging.
Storing the Loader
If the skid-steer loader is to be stored for a period in excess of two months, the
following procedures are suggested:
1. Fully inflate the tires.
2. Lubricate all grease zerks.
3. Check all fluid levels and replenish as necessary. (Review and follow the
engine manufacturers recommendations from the Engine Operator’s Manual.)
4. Add stabilizer to the fuel per the fuel supplier’s recommendations. If the fuel
has a mixture of BioDiesel, empty the fuel tank before storing.
5. Turn the electrical battery disconnect switch to its OFF position and remove
the battery, charge it fully and store in a cool, dry location.
6. Protect against extreme weather conditions such as moisture, sunlight and
temperature.
To Next Page
Loading...