50950260/AP1216 53
Removing Loader from Storage
1. Check the tire air pressure and inflate the tires if they are low.
2. Connect the battery and check that the electrical battery disconnect switch is
turned to its ON position.
3. Check all fluid levels (engine oil, transmission/hydraulic oil, engine coolant
and any attached implements). (Review and follow the engine manufacturers
recommendations from the Engine Operator’s Manual.)
4. Start the engine. Observe all gauges. If all gauges are functioning properly
and reading normal, move the machine outside.
5. Once outside, park the machine and let the engine idle for at least five min-
utes.
6. Shut the engine off and walk around machine. Make a visual inspection look-
ing for evidence of leaks.
To Next Page
Loading...