50950260/AP1216 61
CHAPTER 5
SERVICE
Before servicing the machine, unless expressly
instructed to the contrary, exercise the MAN-
DATORY SAFETY SHUTDOWN PROCEDURE (page 6).
After service has been performed, be sure to restore all guards,
shields and covers to their original positions before resuming
loader operation.
This Service chapter details procedures for performing routine maintenance
checks, adjustments and replacements. Most procedures are referred to in the
Troubleshooting and Maintenance chapters of this manual. Refer to the Mainte-
nance Interval Chart (page 111) for service intervals. Refer to the separate engine
manual for engine-related adjustments, lubrication and service procedures.
Note: All service procedures, except those described under the Dealer Services
topic are owner-operator responsibilities.
Important: Always dispose of waste lubricating oils and hydraulic fluids
according to local regulations or take to a recycling center for disposal. Do not
pour onto the ground or down the drain.
Dealer Services
The following areas of component service, replacement and adjustments require
special tools and knowledge for proper servicing and should be performed only
by your authorized Gehl skid-steer loader dealer: hydrostatic drive components,
hydraulic system pumps, valves, hydraulic cylinders, electrical components
(other than battery, fuses or relays).
Figure 1 Engine Com-
partment - DPF Models
1. Air Cleaner
2. Exhaust Tube
3. Radiator/Cooler
4. Coolant Recovery Tank
5. Hydraulic Oil Filter
6. Engine Oil Dipstick
7. Engine Oil Fill Cap
8. Engine Oil Filter
9. Fuel Filter
10. Fuel Pump
11. Water Trap
12. DPF Cannister
To Next Page
Loading...