70 50950260/AP1216
Engine Service
Check Engine Mounting Hardware
All bolts that secure the engine mounting brackets to the engine and the loader
frame should be checked and re-tightened as necessary.
Allow hot engine and hydraulic system compo-
nents to cool before servicing.
Checking Engine Oil Level
Important: For new units, the initial oil
change should be after the first 50 hours.
Open the rear door and engine access
cover. Pull out the dipstick and check the
oil level. Markings on the dipstick repre-
sent FULL and LOW (add oil) levels.
Refer to the Maintenance Interval Chart
(page 97) for the service interval for
replacing the engine oil and filter.
Figure 9 Oil Dipstick
and Fill Cap - DPF Models
1. Oil Dipstick
2. Oil Fill Cap
1
2
Figure 10 Oil Dipstick
and Fill Cap - Non-DPF Models
1. Oil Dipstick
2. Oil Fill Cap
1
2
To Next Page
Loading...