50950260/AP1216 69
Access
1. Open the rear door and engine access cover.
2. Unlatch the clamps on the air cleaner and remove the cover. Clean out any
dirt built up in the cover assembly.
Outer Element
1. Carefully pull the outer element out of the housing. Never remove the inner
element unless it is to be replaced.
2. Clean out any dirt built up in the housing. Leave the inner element installed
during this step to prevent debris from entering the engine intake manifold.
3. Replace the outer element.
Note: Manitou Americas does not recommend cleaning the outer element.
4. Use a trouble light inside the outer element to inspect for spots, pinholes or
ruptures. Replace the outer element if any damage is noted. The outer element
must be replaced if it is oil- or soot-laden.
Inner Element
Note: Replace the inner element only if it is dirty or if the outer element has been
replaced three times.
1. Before removing the inner element from the housing, clean out any dirt built
up in the housing. Leave the inner element installed during this step to pre-
vent debris from entering the engine intake manifold.
2. Remove the inner element.
Reinstallation
1. Check the inside of the housing for any damage that may interfere with the
elements.
2. Be sure that the element sealing surfaces are clean.
3. Insert the element(s), making sure that they are seated properly.
4. Secure the cover to the housing with clamps.
5. Check the hose connections and be sure they are all clamped and tightened
properly.
6. Reset the restriction indicator by pressing the reset button.
To Next Page
Loading...
Need help?
General
