Gehl R105 X-Series - Status, Maintenance and Error Code Screens

38 50950260/AP1216
Single Gauge Display
Displays single real time operating parameters.
Switch between parameters using the navigation
button (M, Figure 17). Used for various functions,
depending upon screen and context.
Regeneration Screens (DPF Models)
These screens are associated with Diesel
Particulate Filter (DPF) regeneration procedures
and maintenance. See “Diesel Particulate Filter
(DPF) Regeneration Procedures (DPF Models)” on
page 55.
Secondary Screens
All Secondary Screens
Secondary screens are accessed by holding down
the ok button (N, Figure 17) for 10 seconds while
the Dual Gauge Display screen is displayed. Press
the left/right side of navigation rocker button (M,
Figure 17) to switch between secondary screens.
Revision Screen
Displays information center electronic display
software information.
Table 2: Status, Maintenance and Error Code Screens
Display Mode Description
212
1234.5
n/min
22 %
REVISIONS
DISPLAY
04 14 2014
MCU
MAIN KEYPAD
ABCDEFG
ROAD LIGHTS KEYPAD
HEATER/WIPER KEYPAD
ABCDE
************
************