64 50950260/AP1216
Adjustments
Control Handles
The control handles do not require routine adjustment. Refer to the Service
Manual for the initial setup procedure.
Fuel Sender
The fuel sender, located in the fuel tank, sends a signal to the fuel gauge indi-
cating the amount of fuel left in the fuel tank.
Check the fuel sender periodically to ensure that the mounting screws are tight
and that there is no fuel seepage around the gasket. If replacement is required,
apply an RTV or gasket sealant around the gasket when restoring the fuel sender.
Drive Chains
The drive chains do not require routine adjustment. Refer to the Service Manual
for the initial setup procedure.
Removing Foreign Material
The loader should be cleared daily of dirt and other foreign materials in the fol-
lowing areas:
• around the lift cylinders
• at the front of the loader
• on the hitch, especially around tilt cylinder
• around the hydraulic oil reservoir breather
• in the engine compartment
• in the operator’s compartment
Important: Build-up of foreign materials in these areas can interfere with the
operation of the loader, cause component damage or become a fire hazard.
To Next Page
Loading...
Need help?
General
